Autoterm AIR 2D-24V Air parking heater 2kW for diesel oil (without control panel)

Thanks to its compact design, AUTOTERM Air 2D can be easily installed in almost any land or sea vehicle and is supplied with a complete mounting kit. The device uses fresh air from outside or a well-ventilated room and then heats it quickly, thus providing comfort and warmth in low-temperature environments. The maximum power of the heater is 2 kW and it is able to produce up to 86 m3 of hot air per hour while maintaining the set temperature.

The Autoterm parking heating (formerly Planar 2D) is designed to operate in difficult conditions and in continuous mode, and is particularly appreciated for its reliability and safety. It is characterized by low fuel and power consumption, as well as the possibility of adjustment in various modes.

Autoterm Air 2D is available for vehicles with 12 V and 24 V on-board voltage.

The Autoterm 2D parking heating installation kit includes:
    Autoterm "Extra Quiet" fuel pump
    Exhaust muffler (17 x 9 x 5 cm)
    Rubber handle for the dosing pump
    Dosing pump wiring harness
    Radiator wiring harness
    Intake air pipe with built-in silencer
    Heat protection cable
    Exhaust pipe tip + clamp
    Tank inlet pipe
    5.5 m fuel line (if it turns out to be too short, you can order it by the meter)
    Fuel line connector
    Exhaust pipe made of corrugated sheet metal, 1 m
    Screws, nuts, clamps, heat shrink tubes
    cable ties
    User manual

Fuel tanks are needed to supply fuel that is not taken from the vehicle's tank (e.g. in boats).

Autoterm Air is also available in a 4D version with a heating power of 4 kW in a 12V or 24V version. Which type of parking heater is right for you depends on your traveling habits, goals and the insulation of your vehicle. The 4 kW parking heater quickly turns smaller campers into a sauna, even on the lowest setting, and you have to open the window while heating. When in doubt, choose a lower heat and let it run at a higher setting, rather than running the larger heat at a lower setting.

AUTOTERM Air 2D - parameters
Technical characteristics: High/Low
Voltage: 12V or 24V
Heating medium: Air
Heating power: 2.0kW / 0.8kW
Volume of heated air: 86m3/h / 34m3/h
Power consumption: 29 W / 10 W
Max. operating altitude (above sea level) 1600m (standard control unit)/2500m (high altitude control unit)
Fuel: Diesel
Fuel consumption: 0.24 l/h / 0.1 l/h
Control mode: Manual, standard remote control, modem
Compatible control panels: PU-5, PU-10, PU-22, PU-27, Pu-28 Comfort Control
Device weight: 2.9 kg
Set weight: 6.4 kg
Device dimensions: 310x119x145 mm